Models Showcase

Print upright; cap separately. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.

Food-safe PETG, or line with paper cases. Prints as shown on its outline, no supports. The lid prints as a separate part, top down.

Opaque matt filament keeps the beam crisp. Print it as shown, then turn it over so the floor becomes the top. The lid is the base; needs a 70 mm LED puck. Print floor-down as shown, then turn it over to use it. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.

Line the roof tray before planting live sedum. Prints as shown on its floor, no supports. The 2 drawers print separately from the case. Stacked parts are fused into one print.

Two colours, food-safe PETG. Print it as shown, then turn it over so the floor becomes the top. The cap becomes the base. Print floor-down as shown, then turn it over to use it. The lid prints as a separate part, top down.

Print upright as shown, then lay it on the flat face. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.

Print in a stone grey. Silica gel sachets keep seeds dry. Prints as shown on its floor, no supports. The 3 drawers print separately from the case.

Print in a calm neutral; the lidded neck prints as one piece. Prints as shown on its floor, no supports. The added base's lid prints separately. Stacked parts are fused into one print.

Print the upper deck in white and the module in grey. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Print the hood upside down, roof on the plate.

Stand it on a drip saucer. Print in green and timber brown. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The added base's lid prints separately.