Models Showcase

Print a set at 100, 88 and 76 % so they nest one inside the next. Prints as shown on its floor, no supports.

Rinse twice a day. Empty the bottom tray each time. Prints as shown on its floor, no supports. Stacked parts are fused into one print.

Use a wooden pestle, not a stone one. Print in PETG with 4 walls. Prints as shown on its floor, no supports.

Print in clear PETG to see the fill lines from inside. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.

Print the lid face down. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.

Food-safe PETG. Blend 1 g sodium alginate into 200 ml juice and dissolve 2.5 g calcium chloride in 500 ml water. Prints as shown on its floor, no supports.

Float it in a jug of fresh water and add rice inside until the waterline sits on 0. Then each 20 g sinks it 12.5 mm to the next line. Prints as shown on its floor, no supports.

Peel a medium egg while still hot, push it in, press the lid down and hold it with a rubber band; chill for 10 minutes in iced water. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.

PETG with 5 mm walls and 15% infill so the walls trap air. Fill to 2 cm below the rim, freeze for about 20 hours, then lift the block out before the bottom freezes. Prints as shown on its floor, no supports.

Clear or natural PETG so you can see the egg. Fill with cold water to just below the rim. Prints as shown on its floor, no supports.