Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print the box and the lid as separate parts, flat side down, with no supports. For PETG, a thin layer of glue stick helps the lid release from the plate. If the lid fits too tight, scale it to 99% in your slicer. Always put knives in blade-first into the lanes. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Use an 8 mm wooden dowel about 236 mm long as the axle. Fits rolls up to 220 mm long and 80 mm across in a drawer 100 mm deep. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
For packets up to 70 mm wide. Needs a drawer 120 mm deep, with a finger's width in front of the slots. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PLA is fine in the fridge; wash it by hand, not in the dishwasher. Sized for a fridge drawer 100 mm deep. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Glue the neck plate onto the shelf inside the rim, then the cap screws on. Change the cap lettering for each brick. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
The base ring prints separately. Needs 55 mm of drawer depth. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Print the tray, the drawer and its case separately. Prints as shown on its floor, no supports. The drawer prints separately from the case. Stacked parts are fused into one print.
Print the lid face down. A snug fit stops the lid turning in a bag. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Blow gently across the hole, not into it. Print with 3 walls so the jar rings clearly. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print in grey or stone-effect filament. Place it lid-down. Prints as shown on its floor, no supports. The twist-lock lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.