Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Drop a folded stack of tissues into the main box under the slotted top; the bin flap swings in and the bin's lid lifts off to empty. Prints as shown on its floor, no supports. The added base's lid prints separately. Stacked parts are fused into one print.
PETG. Fill with oats, lavender, chamomile or rose petals; hang it from the tap by the ring on its tower while the bath runs. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print the cap in brown and the body in tan; the ring stands in the gap round the centre post. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Use the screw lid when travelling; rinse the cup daily. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print in stone grey; core in a silk colour if you swap filament. Prints as shown on its outline, no supports. The lid prints as a separate part, top down.
Body and head in one print; lid separate. Add a felt disc inside. Prints as shown on its floor, no supports. The added base's lid prints separately. Stacked parts are fused into one print.
Deep red, gold or black silk PLA. Lid prints separately. Prints as shown on its outline, no supports. The lid prints as a separate part, top down.
Silk PLA; glue in a 50 mm round mirror with a dot of silicone. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.