Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Prints as shown on its floor, no supports.
Print the legs separately, they screw or press into the floor. Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Stick a mirror tile on the floor, run a battery LED strip round the walls below the ledge, and lay a one-way-mirror acrylic sheet on the ledge. Prints as shown on its floor, no supports.
Print in gold or rose; engrave initials with a marker or a rotary tool on the body. Prints as shown on its outline, no supports.
Push stud posts through the pod holes; the backs sit safely in the chamber underneath. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print in a deep green; a 0.2 mm layer keeps the slit ends crisp. Prints as shown on its outline, no supports.
Print the cap in brown and the body in tan; the ring stands in the gap round the centre post. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print in a pale gold; the tilted ring ends make tidy cradles for single rings. Prints as shown on its outline, no supports.