Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Stick a mirror tile on the floor, run a battery LED strip round the walls below the ledge, and lay a one-way-mirror acrylic sheet on the ledge. Prints as shown on its floor, no supports.
Print in gold or rose; engrave initials with a marker or a rotary tool on the body. Prints as shown on its outline, no supports.
Push stud posts through the pod holes; the backs sit safely in the chamber underneath. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print in a deep green; a 0.2 mm layer keeps the slit ends crisp. Prints as shown on its outline, no supports.
Print the cap in brown and the body in tan; the ring stands in the gap round the centre post. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print in a pale gold; the tilted ring ends make tidy cradles for single rings. Prints as shown on its outline, no supports.
Print three or four; 8 mm dowel. Prints as shown on its floor, no supports.
Print upright; push the dowel into the post. Prints as shown on its floor, no supports.
Print in stone grey; core in a silk colour if you swap filament. Prints as shown on its outline, no supports. The lid prints as a separate part, top down.
Print disc face down; two screws through the boss. Prints flat as a plate, no supports. Stacked parts are fused into one print.