Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Use an 8 mm wooden dowel about 236 mm long as the axle. Fits rolls up to 220 mm long and 80 mm across in a drawer 100 mm deep. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
For packets up to 70 mm wide. Needs a drawer 120 mm deep, with a finger's width in front of the slots. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PLA is fine in the fridge; wash it by hand, not in the dishwasher. Sized for a fridge drawer 100 mm deep. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Glue the neck plate onto the shelf inside the rim, then the cap screws on. Change the cap lettering for each brick. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
The base ring prints separately. Needs 55 mm of drawer depth. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Print the tray, the drawer and its case separately. Prints as shown on its floor, no supports. The drawer prints separately from the case. Stacked parts are fused into one print.
Print in PETG. For very fine tea, line it with a paper filter. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print in a food-safe PETG and line the box with baking paper. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Fill the gap with sand, soak it, and cover with a damp cloth. Works best in dry heat with a breeze. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print in clear PETG to see the fill lines from inside. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.