Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Number the cells with a marker, or cover each one with paper to open. Prints as shown on its floor, no supports.
Fits an A5 sheet rolled tightly. Print each capsule in a different colour. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print in black or dark green. Prints as shown on its floor, no supports.
Tape about 20 notes end to end and fold them like a fan. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints flat. Put the smallest pieces in the front row and the biggest at the back, then look from the front edge. Prints as shown on its floor, no supports.
Print the sleeve and drawer in contrasting colours; the drawer pushes out from either end. Prints as shown on its floor, no supports. The drawer prints separately from the case.
Write the years on the dividers with a paint pen; the lid keeps the stubs from fading. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
One number per bay; the last two bays take the small candles and a lighter. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
The card stands in the slot on the stage; tuck a folded note under the lid. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.