Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Prints flat. Put the smallest pieces in the front row and the biggest at the back, then look from the front edge. Prints as shown on its floor, no supports.
Print the sleeve and drawer in contrasting colours; the drawer pushes out from either end. Prints as shown on its floor, no supports. The drawer prints separately from the case.
Write the years on the dividers with a paint pen; the lid keeps the stubs from fading. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
One number per bay; the last two bays take the small candles and a lighter. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
The card stands in the slot on the stage; tuck a folded note under the lid. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print in red or green with the word in gold; envelopes stand in three rows. Prints as shown on its floor, no supports.
Roll each belt and stand it in its bay from white on the left to black on the right. Prints as shown on its floor, no supports.
Slots take standard graded slabs about 7 mm thick. Prints as shown on its floor, no supports.
Print the lid with the moon face up; a dark purple or black filament with gold text looks best. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Pockets fit standard elongated cents up to 33 x 20 mm; print more trays and stack them. Prints as shown on its floor, no supports. Stacked parts are fused into one print.