Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print upright; stand it in a tray of damp perlite. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Opaque matt filament keeps the beam crisp. Print it as shown, then turn it over so the floor becomes the top. The lid is the base; needs a 70 mm LED puck. Print floor-down as shown, then turn it over to use it. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print in a stone grey. Silica gel sachets keep seeds dry. Prints as shown on its floor, no supports. The 3 drawers print separately from the case.
Print in a calm neutral; the lidded neck prints as one piece. Prints as shown on its floor, no supports. The added base's lid prints separately. Stacked parts are fused into one print.
Print the upper deck in white and the module in grey. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Print the hood upside down, roof on the plate.
Stand it on a drip saucer. Print in green and timber brown. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The added base's lid prints separately.
Print in silver grey; the spinning base needs 6 mm steel balls. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Print in terracotta or matte black; lid prints separately. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print in batches; one colour per series. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print in white with the lid relief in a second colour. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.