Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print in concrete grey with a rust-red water tower. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print face down in a sandstone tone; stand it on its long edge. Prints as shown on its floor, no supports.
Stand it on a drip saucer. Print in green and timber brown. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The added base's lid prints separately.
Print flat in a bright colour. Scale the width with the slot to fit thicker edges.
Print flat at 0.2 mm layers; PETG flexes without snapping.
Body and head in one print; lid separate. Add a felt disc inside. Prints as shown on its floor, no supports. The added base's lid prints separately. Stacked parts are fused into one print.
Print lying flat in dark green; all strokes come out solid.
Print flat; glow-in-the-dark or translucent PETG suits it.
Print in silver grey; the spinning base needs 6 mm steel balls. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Translucent or glitter PETG; print upright with no supports. Prints as shown on its floor, no supports.