Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print in a soft pastel; matte PLA shows the engraving. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print open end up, then stand it on its open end. Print floor-down as shown, then turn it over to use it.
Print upright. Holds a portrait postcard (105 x 148). Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print in dark blue or black so the lit stars stand out. Prints as shown on its floor, no supports.
Print in a calm neutral; the lidded neck prints as one piece. Prints as shown on its floor, no supports. The added base's lid prints separately. Stacked parts are fused into one print.
Print as many rooms as storeys; a dab of museum putty locks the stack. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
PETG or PLA; use backflow cones only and never leave them burning unattended. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
Print the upper deck in white and the module in grey. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Print the hood upside down, roof on the plate.
Print in white or dark green. Line with 0.3 mm acetate for a closed case. Prints as shown on its floor, no supports.
Print in sandstone colours; the planters need no drainage for moss. Prints as shown on its floor, no supports.