Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Food-safe PETG. Prints as shown on its outline, no supports.
PLA or PETG. Print two. Prints as shown on its outline, no supports.
PETG for springy legs. A 10 mm coin motor and CR2032 cell. Prints as shown on its outline, no supports.
Arches print bridged; no supports at 0.2 mm layers. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
Opaque matt filament keeps the beam crisp. Print it as shown, then turn it over so the floor becomes the top. The lid is the base; needs a 70 mm LED puck. Print floor-down as shown, then turn it over to use it. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
PETG or ASA outdoors. Fits solar heads 58 to 70 mm wide. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print upright; ledges self-support at 45 degrees. Prints as shown on its floor, no supports.
Line the roof tray before planting live sedum. Prints as shown on its floor, no supports. The 2 drawers print separately from the case. Stacked parts are fused into one print.
Arches bridge cleanly; print walls at 3 mm. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Fits a 6 x 4 inch landscape photo. LED candles only. Prints as shown on its floor, no supports. Stacked parts are fused into one print.