Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print flat in PETG; green or terracotta suits most pots.
Print without supports; 3 perimeters. Prints as shown on its floor, no supports.
PETG outdoors; top up the moat after hot days. Prints as shown on its floor, no supports.
Needs a 25 to 35 mm hanging bell and a bamboo skewer. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
Print standing as shown; the 4 mm wall is solid. Prints as shown on its outline, no supports.
Print as shown (profile on the bed), 100 % infill on the arm. Prints as shown on its outline, no supports.
Deck on the bed. Print it as shown, then turn it over so the floor becomes the top. Needs ball chain and a mirror tile. Print floor-down as shown, then turn it over to use it.
Print standing on one end in translucent PETG, vase-like.
Print eight, same settings so they weigh the same. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print flat in PETG or TPU so it flexes without cracking.