Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print the column pieces standing up with 4 walls and 20–25% infill; PETG gives a stiffer stand. Screw the pieces together by hand until they seat; don’t overtighten. Prints as shown on its floor, no supports. Stacked parts are fused into one print. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print the column pieces standing up with 4 walls and 20–25% infill; PETG gives a stiffer stand. Screw the pieces together by hand until they seat; don’t overtighten. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Use 16-25 mm marbles or wooden beads. The dot numbers are engraved in the floor of each bay. Prints as shown on its floor, no supports.
Thread two hook-and-loop straps through the side slots round the rollator seat frame. Prints as shown on its floor, no supports.
Needs a 25 to 35 mm hanging bell and a bamboo skewer. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
PETG, 1.6 mm, so it flexes; thread a cord or a dressing gown belt. Prints flat as a plate, no supports.
PETG; measure your knob, the cup is 56 mm inside. Prints as shown on its floor, no supports.
Print flat in PETG.
Matt black filament gives the best contrast. Prints flat as a plate, no supports.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.