Night Cell

Put the phone to bed charging out of sight

A tall quiet cell where the phone sleeps. Drop it in at bedtime: it stands on two inner ledges with the charging plug hanging free below, the cable leaves by a notch at the back, and the arcaded front shows nothing of the screen, so the phone charges out of sight and out of reach.

Customize this model

Size: 89 × 34 × 180 mm
Shape: Rectangular
Walls: 2.4 mm
Volume: 10.0 cm³
Est. weight (PLA): 12.4 g
Parts to print: 1
Category: Cables & charging
Made by: Krypto
Built in: 34 steps

What’s in it

Rectangular, 89 × 34 × 180 mm, with 2.4 mm walls
1 hole in the walls
Engraved text: “OFFLINE”
1 patterned wall panel (engraved)

How to print it

Print upright; ledges self-support at 45 degrees.

Prints as shown on its floor, no supports.

Filament: at most about 12.4 g of PLA printed solid (roughly $0.25 at $20 per kg); normal infill uses less.

To get the files, open it in the generator and choose File › Download STL (one file per part) or Download 3MF (every part on one plate).

Questions

What size is the night Cell model?

The night Cell model measures 89 × 34 × 180 mm (width × depth × height). You can change every size in the free SO3D.xyz generator before you download it.

Does it need supports?

No. Print upright; ledges self-support at 45 degrees. Prints as shown on its floor, no supports.

How much filament does it use?

At most about 12.4 g of PLA (10.0 cm³ printed solid), roughly $0.25 of filament at $20 per kg. Normal infill uses less.

Can I change it?

Yes. Open it in the SO3D.xyz generator (free, in your browser), change the size, walls, dividers, holes, text or anything else, then download it as STL or 3MF for your slicer.