Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print three or four; 8 mm dowel. Prints as shown on its floor, no supports.
Print upright; push the dowel into the post. Prints as shown on its floor, no supports.
Print in stone grey; core in a silk colour if you swap filament. Prints as shown on its outline, no supports. The lid prints as a separate part, top down.
Print disc face down; two screws through the boss. Prints flat as a plate, no supports. Stacked parts are fused into one print.
PETG for spring. Print flat.
Print in a pearl or silk PLA. Prints as shown on its outline, no supports.
Arches bridge cleanly; print walls at 3 mm. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print upright; slots bridge cleanly at 2.4 mm walls. Prints as shown on its floor, no supports.
Body and head in one print; lid separate. Add a felt disc inside. Prints as shown on its floor, no supports. The added base's lid prints separately. Stacked parts are fused into one print.
Print in gold, bronze or silk PLA. Prints as shown on its outline, no supports.