Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print in black PLA. Tape a square of kitchen foil with a needle hole over the 6 mm hole, and tape the lid shut. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Stand a 220 x 110 mm sheet of 2-3 mm clear acrylic (or photo-frame glass) diagonally from the front-left to the back-right corner. Use a battery tealight. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down. The added base's lid prints separately.
Print the box and lid; stretch an old sock cuff over each arm hole if you want a curtain. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
Line every inside face of the box, and the inside and skirt of the lid, with overlapping copper or aluminium foil tape. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PETG for outdoors. An old phone running a free motion-triggered camera app works well; run the cable out under the lid. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The added base's lid prints separately.
Check with a reptile vet first. Use a fridge kept only for this, with a thermometer, and weigh the tortoise every week. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PETG. Fill with oats, lavender, chamomile or rose petals; hang it from the tap by the ring on its tower while the bath runs. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Fill with a handful of 4.5 mm steel BBs (or dry lentils for a softer sound), then screw the lid on. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Fit a 60-100 mm magnifying lens over the front port, turn the phone image upside down, and lock its rotation; try each slot until the picture is sharp. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
Print the sleeve and drawer in contrasting colours; the drawer pushes out from either end. Prints as shown on its floor, no supports. The drawer prints separately from the case.