Models Showcase

Slide the phone into the slot, camera facing the stage. A free stop-motion app shows the last frame as a ghost to line up the next. Prints as shown on its floor, no supports.

Fill the dripper (a drop of milk makes the splashes white), fill the pool to the brim, slot the phone in and film at 240 fps. Prints as shown on its floor, no supports. Stacked parts are fused into one print.

Print in black PLA. Tape a square of kitchen foil with a needle hole over the 6 mm hole, and tape the lid shut. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.

Fit a 60-100 mm magnifying lens over the front port, turn the phone image upside down, and lock its rotation; try each slot until the picture is sharp. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.

Glue two 30 mm, 5x lenses over the eye ports; print stereo pairs 63 mm apart on card and slip them in the back slot. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.

Lay coated paper on the floor, leaves on top, then a 2 mm glass sheet on the ledges; expose 10-15 minutes in sun. Prints as shown on its floor, no supports.

Uses the lazy-Susan ball bearing base. Matt deck colour. Prints as shown on its floor, no supports. The lid prints as a separate part, top down. The turntable ring prints separately and runs on 6 mm BBs.

Print six; 10 mm ribbon and craft glue. Prints as shown on its floor, no supports.

Print flange up at 0.12 mm layers; scale 1 % if the fit is tight. Prints as shown on its floor, no supports. Stacked parts are fused into one print.

Matt black PLA. Check your flash head size (here 77 x 47 mm). Prints as shown on its floor, no supports. Stacked parts are fused into one print.