Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print drawers in a darker colour for the kaidan look. Prints as shown on its floor, no supports. The 3 drawers print separately from the case.
Print the lid separately, upside down. Prints as shown on its outline, no supports. The lid prints as a separate part, top down.
Twelve 6 x 3 mm magnets, same polarity rule. Prints as shown on its floor, no supports. The drawer prints separately from the case.
PETG; clean with alcohol before pouring agar. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print in stone grey; core in a silk colour if you swap filament. Prints as shown on its outline, no supports. The lid prints as a separate part, top down.
Print body and lid flat. Optional 10 mm magnet glued under the floor. Prints as shown on its outline, no supports. The lid prints as a separate part, top down.
Print in white or pearl PETG. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PETG. Print body and lid flat. Prints as shown on its outline, no supports. The lid prints as a separate part, top down.
PETG, 3 walls; PTFE tape on the thread. Test it with your keys first. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print upright; stand it in a tray of damp perlite. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.