Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Press or glue a 10 mm disc magnet into each seat from below. Prints as shown on its outline, no supports.
Glue cut-out paper layers to each frame. Line the lid windows with tracing paper for soft light. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
Print a few in different filaments to colour-code. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Fill with fine dry sand or salt and hang it from a Y of string about 1 m long over dark card. Tape over the bottom hole until you let go. Prints as shown on its floor, no supports.
PETG; wipe dye off straight away. Twist the damp shirt flat round a fork in the centre circle, band it into six wedges along the ribs. Prints as shown on its floor, no supports.
Print in orange with the pumpkin in black. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print in PETG; the drained floor of the sponge cup lets slip run off. Prints as shown on its floor, no supports.
Rest the canvas on the raised inner ring; scrape the cured drips out of the moat and reuse them as paint skins. Prints as shown on its floor, no supports.
Glue a sheet of glass or acrylic in the slab bay for the smoothest roll-out. Prints as shown on its floor, no supports.
Fill through the base; tilt it and a marker drops out of the top hole. Prints as shown on its floor, no supports. Stacked parts are fused into one print.