Showcase
Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Store a wax seal stamp and sticks
A fitted case for a wax seal stamp and three sticks of sealing wax, with a telescoping lid shown beside it.
Printing notes
272.5 cm³
Volume
337.9 g
Est. weight
5,964
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
MAIN PURPOSE: Hold calligraphy pens, nibs and ink
Three lanes for pen holders and nibs, with a round holder for the ink bottle joined to the side.
Printing notes
59.5 cm³
Volume
73.8 g
Est. weight
1,696
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Sort sketching pencils by grade
Six lanes for drawing pencils from hard to soft, with 2H, HB, 2B, 4B, 6B and 8B engraved at the end of each lane, and a telescoping lid shown beside it.
Printing notes
89.7 cm³
Volume
111.3 g
Est. weight
16,356
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
MAIN PURPOSE: Spin art supplies in six sections
A six-section hexagon art station with a large centre hub that spins on BBs.
Printing notes
472.2 cm³
Volume
585.6 g
Est. weight
5,944
Triangles
Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
MAIN PURPOSE: Spin art supplies within easy reach
An eight-section art caddy with a centre hub that spins on BBs, with ART on the side.
Printing notes
701.1 cm³
Volume
869.4 g
Est. weight
6,932
Triangles
Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.