Models Showcase

Print the sleeve upright and the two drawers flat; line the cells with felt for wooden pieces. Prints as shown on its floor, no supports. The 2 drawers print separately from the case.

Print the lid with the moon face up; a dark purple or black filament with gold text looks best. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.

Sized for travel checkers up to 34 mm across; scale the tubes for full-size checkers. Prints as shown on its floor, no supports. The lid prints as a separate part, top down. The added bases' lids print separately.

Holes fit 12 mm toggles, 7 mm rotary encoders and a 22 mm start button; the back port takes a USB-C cable. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.

For dwarf species, glue fine mesh behind the vents. PETG takes the damp better than PLA. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.

Print the cap in brown and the body in tan; the ring stands in the gap round the centre post. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.

Print the turntable ring in a contrasting colour and drop in 6 mm balls. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.

Print the lid in a speckled filament for a real egg look. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.

Print in PETG; the slots let the goggles drip dry in the bag. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.

PETG; wash in warm soapy water, not the dishwasher. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.