Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Wind about 60 turns of 0.3 mm enamelled wire on the tube; use a 1N34A germanium diode, a crystal earpiece, 20 m of aerial wire and a ground to a metal water pipe. Prints as shown on its floor, no supports.
Holes fit 12 mm toggles, 7 mm rotary encoders and a 22 mm start button; the back port takes a USB-C cable. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
PETG or ASA near the iron. Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.
Prints flat as a plate, no supports.
Prints as shown on its floor, no supports.
A drop of glue holds the bit for good. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints flat as a plate, no supports.
Prints as shown on its outline, no supports.
Print two in PETG or ASA. Prints flat as a plate, no supports.