Wire Meet

Hold two wires end to end for soldering

Feed the two wires to be joined through matching holes in the end walls and the two inner walls until the stripped ends meet in the middle bay: they are held straight, level and end to end, so you can twist or lap them and solder with both hands free. Two hole sizes suit thin and medium wire.

Customize this model

Size: 90 × 30 × 30 mm
Shape: Rectangular
Walls: 3.0 mm
Volume: 15.9 cm³
Est. weight (PLA): 19.7 g
Parts to print: 1
Category: Electronics & robotics
Made by: Krypto
Built in: 45 steps

What’s in it

Rectangular, 90 × 30 × 30 mm, with 3.0 mm walls
2 dividers
8 holes in the walls

How to print it

PETG or ASA near the iron.

Prints as shown on its floor, no supports.

Filament: at most about 19.7 g of PLA printed solid (roughly $0.39 at $20 per kg); normal infill uses less.

To get the files, open it in the generator and choose File › Download STL (one file per part) or Download 3MF (every part on one plate).

Questions

What size is the wire Meet model?

The wire Meet model measures 90 × 30 × 30 mm (width × depth × height). You can change every size in the free SO3D.xyz generator before you download it.

Does it need supports?

No. PETG or ASA near the iron. Prints as shown on its floor, no supports.

How much filament does it use?

At most about 19.7 g of PLA (15.9 cm³ printed solid), roughly $0.39 of filament at $20 per kg. Normal infill uses less.

Can I change it?

Yes. Open it in the SO3D.xyz generator (free, in your browser), change the size, walls, dividers, holes, text or anything else, then download it as STL or 3MF for your slicer.