Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
The tube takes three rolled overgrips; dampeners go in the small bays. Prints as shown on its floor, no supports. The lid prints as a separate part, top down. The added base's lid prints separately.
Needles go in the screw-top tube so they never end up in a toe pad. Prints as shown on its floor, no supports. The added base's lid prints separately.
Cups fit boules up to 76 mm; the centre box holds the jack and a measuring tape. Prints as shown on its floor, no supports.
The cups take standard tape rolls; the box takes stick wax and a lace hook. Prints as shown on its floor, no supports.
The small screw-top keeps the needles; the tube takes pumps up to 32 mm. Prints as shown on its floor, no supports. The added base's lid prints separately.
Screw to the wall through the two keyholes; PETG for a garage. Prints as shown on its floor, no supports.
The cup takes handles up to 58 mm; feed the charger cable through the back slot. Prints as shown on its floor, no supports.
Print in PETG; the slots let the goggles drip dry in the bag. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PETG; wash in warm soapy water, not the dishwasher. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Holds six feather or nylon shuttles stacked nose-down. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.