Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print the heart vessel in white; fill the two cups with contrasting sand. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Add a pinch of calcium powder, drop in the crickets, cap it and shake gently. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
PETG; PVA peels off it when dry. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Food-safe PETG, 3 walls so it is watertight. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print in PLA; fill with dry sand and tape the lid shut. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PLA or PETG; line the trays with felt. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PLA or PETG; print the lid face down for a flat top. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Fill the race with 6 mm airsoft BBs. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
PETG resists oils better than PLA. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print lid and drum flat; a drop of glue on the thread once filled. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.