Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print upright. Prints as shown on its floor, no supports.
Print in a pearl or silk PLA. Prints as shown on its outline, no supports.
PETG; seal inside with a coat of resin for permanent inks. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print it as shown, then turn it over so the floor becomes the top. PETG. Print floor-down as shown, then turn it over to use it.
PETG or ASA outdoors. Fits solar heads 58 to 70 mm wide. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print upright, no supports. Prints as shown on its floor, no supports.
Pause at each terrace for a colour change: dark base to white summit. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print two, one for each city, in matching colours. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
PETG or PLA; use backflow cones only and never leave them burning unattended. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
Print in sandstone colours; the planters need no drainage for moss. Prints as shown on its floor, no supports.