Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Push stud posts through the pod holes; the backs sit safely in the chamber underneath. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Tips rest in the chamber below; a damp paper towel in the base keeps them fresh. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print upright; pause before the foot is closed to add sand for weight. Prints as shown on its outline, no supports. Stacked parts are fused into one print.
Print disc face down; two screws through the boss. Prints flat as a plate, no supports. Stacked parts are fused into one print.
Print in a pearl or silk PLA. Prints as shown on its outline, no supports.
Print with 4 walls so the post stays stiff. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print the post with 4 walls. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports.