Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print upright in PLA or PETG with no supports. Use PETG if it will sit near a sink or dishwasher. Prints as shown on its floor, no supports.
Print the three pods separately. The pegs under each pod sit in the pod below; laid flat they act as feet. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Needs a drawer at least 75 mm deep inside. Print the deck separately. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Pockets are sized for typical tools; change each bay's pocket size to fit yours. Prints as shown on its floor, no supports.
For drawers at least 160 mm deep inside. Prints as shown on its floor, no supports.
Empty the catch tray every few days. Print in PETG. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Rinse twice a day. Empty the bottom tray each time. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Add more wagons for bigger parties. Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.