Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print the box and lid; stretch an old sock cuff over each arm hole if you want a curtain. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
Line every inside face of the box, and the inside and skirt of the lid, with overlapping copper or aluminium foil tape. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PETG for outdoors. An old phone running a free motion-triggered camera app works well; run the cable out under the lid. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The added base's lid prints separately.
Check with a reptile vet first. Use a fridge kept only for this, with a thermometer, and weigh the tortoise every week. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Fill with a handful of 4.5 mm steel BBs (or dry lentils for a softer sound), then screw the lid on. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Fit a 60-100 mm magnifying lens over the front port, turn the phone image upside down, and lock its rotation; try each slot until the picture is sharp. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
Print the sleeve and drawer in contrasting colours; the drawer pushes out from either end. Prints as shown on its floor, no supports. The drawer prints separately from the case.
Cross three or four rubber bands through opposite wall holes to hang the egg in the cradle; tie a carrier-bag parachute to the lid ring. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Put each person's name peg or token in a bay; every Sunday give the turntable a quarter turn. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Agree the fine first; empty it into something nice for everyone. Prints as shown on its floor, no supports. Print the hood upside down, roof on the plate.