Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Use MERV 13 or HEPA filter sheet cut to the wall size, and a 5 V USB fan. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Add more wagons for bigger parties. Prints as shown on its floor, no supports.
Glue the lid on. Fits a 17-key tine set; drill the bridge holes to suit. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Leave the lid off overnight so the bar dries hard. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print in clear PETG to see the fill lines from inside. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print in green or gold. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Use calcium chloride refill crystals. Keep away from children and pets. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Line the wedges with felt for delicate pieces. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Size the well to your cap. Prints as shown on its floor, no supports.
Stand it in a baking tray. Rinse after each eruption. Prints as shown on its floor, no supports.