Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Use a ball 40 mm or larger so it can't be swallowed. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print in black or dark green. Prints as shown on its floor, no supports.
Glue cut-out paper layers to each frame. Line the lid windows with tracing paper for soft light. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
Fits pencils up to 19 cm. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Fold kitchen paper strips lengthwise and dip one end in each neighbouring cell. Prints as shown on its floor, no supports.
Tape about 20 notes end to end and fold them like a fan. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Use LED tea lights only, never a flame. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Cut a perforated plastic sheet to rest on the ledge. Never turn reptile eggs. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports. Print the hood upside down, roof on the plate.
Prints as shown on its floor, no supports.