Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Play with 7 counters each and four 4-sided dice, or flip four coins. Prints as shown on its floor, no supports.
The post unscrews from the base for washing. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Number the cells with a marker, or cover each one with paper to open. Prints as shown on its floor, no supports.
For large dogs, scale the cup to 110 mm across. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Use a wooden pestle, not a stone one. Print in PETG with 4 walls. Prints as shown on its floor, no supports.
Size guide: about 1 cm3 per 10 g of body weight; this one holds about 600 cm3. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Sand the hole edges smooth. Print in PETG for strength. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
Print some bins mirrored: the hat tiling uses both hands. Prints as shown on its outline, no supports.
Print in black. Lay the phone torch-up under the hole in the floor. Smaller holes give sharper stars. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Fits an A5 sheet rolled tightly. Print each capsule in a different colour. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.