Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print in a dark colour so no light comes through the walls. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
Print three. Use 20 mm soft balls or rolled paper balls. Prints as shown on its floor, no supports.
Hang a twig from the lid for the chrysalis. Release butterflies within a day. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Prints as shown on its outline, no supports.
Tape over the holes until the bucket is white with mycelium, then uncover and mist daily. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Use cotton or nylon cord. Stand the tank level with the pots or higher. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Hang one per metre of rail. Sand the cedar chips lightly to refresh them. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print in a food-safe PETG and line the box with baking paper. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Fill the gap with sand, soak it, and cover with a damp cloth. Works best in dry heat with a breeze. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Use copper strips or coins and galvanised nails or zinc strips. Prints as shown on its floor, no supports.