Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Needs a drawer at least 75 mm deep inside. Print the deck separately. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Pockets are sized for typical tools; change each bay's pocket size to fit yours. Prints as shown on its floor, no supports.
For drawers at least 160 mm deep inside. Prints as shown on its floor, no supports.
Fits jars up to 45 mm across and 105 mm long; ten jars per insert. Prints as shown on its floor, no supports.
The base ring prints separately. Needs 55 mm of drawer depth. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Print a set at 100, 88 and 76 % so they nest one inside the next. Prints as shown on its floor, no supports.
Print the tray, the drawer and its case separately. Prints as shown on its floor, no supports. The drawer prints separately from the case. Stacked parts are fused into one print.
Empty the catch tray every few days. Print in PETG. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Engrave in a contrasting colour by changing filament at the floor top. Prints as shown on its floor, no supports.
Print the lid face down. A snug fit stops the lid turning in a bag. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.