Models Showcase

Prints as shown on its floor, no supports. Stacked parts are fused into one print.

Print the box and the lid as separate parts, flat side down, with no supports. For PETG, a thin layer of glue stick helps the lid release from the plate. If the lid fits too tight, scale it to 99% in your slicer. Always put knives in blade-first into the lanes. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.

Use an 8 mm wooden dowel about 236 mm long as the axle. Fits rolls up to 220 mm long and 80 mm across in a drawer 100 mm deep. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.

For packets up to 70 mm wide. Needs a drawer 120 mm deep, with a finger's width in front of the slots. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.

PLA is fine in the fridge; wash it by hand, not in the dishwasher. Sized for a fridge drawer 100 mm deep. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.

For deep drawers: table knives need about 220 mm inside. Stand it on a drip mat. Prints as shown on its floor, no supports.

Print the three pods separately. The pegs under each pod sit in the pod below; laid flat they act as feet. Prints as shown on its floor, no supports. Stacked parts are fused into one print.

Use a multi-port USB charger, leave slack in its lead so the drawer opens fully, and don't shut away a charger that runs hot. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.

Glue the neck plate onto the shelf inside the rim, then the cap screws on. Change the cap lettering for each brick. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.

Print the number of bins the badge shows. Because they are identical, any bin fits any spot. Prints as shown on its floor, no supports.