Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print upright in a dark colour so the layers stand out. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print upright in sandstone PLA. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
PETG or ASA outdoors. Print flat.
PETG or ASA outdoors. Fits solar heads 58 to 70 mm wide. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print flat in PETG; green or terracotta suits most pots.
PETG outdoors; top up the moat after hot days. Prints as shown on its floor, no supports.
Print standing on one end in translucent PETG, vase-like.
Print sixteen flat as shown; bars come out solid. Prints as shown on its outline, no supports.
Print in a stone grey. Silica gel sachets keep seeds dry. Prints as shown on its floor, no supports. The 3 drawers print separately from the case.
Print in white or dark green. Line with 0.3 mm acetate for a closed case. Prints as shown on its floor, no supports.