Tafoni Wall

Hang air plants in sandstone-like hollows

A wall garden for air plants after tafoni, the honeycomb hollows wind carves into sandstone cliffs. Seven round cavities of different sizes open in the face; air plants sit on the floor behind the low ones and on the inner shelf behind the high ones, sheltered but in full air and light.

Customize this model

Size (Base A): 200 × 46 × 96 mm
Shape: Rectangular
Walls: 2.4 mm
Volume: 64.2 cm³
Est. weight (PLA): 79.6 g
Parts to print: 1
Category: Garden & plants
Made by: Krypto
Built in: 46 steps

What’s in it

Rectangular, 200 × 46 × 96 mm, with 2.4 mm walls
7 holes in the walls
One more base built on (Base B)
Base B: rectangular, 200 × 46 mm (stacked)

How to print it

Print upright in sandstone PLA.

Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.

Filament: at most about 79.6 g of PLA printed solid (roughly $1.59 at $20 per kg); normal infill uses less.

To get the files, open it in the generator and choose File › Download STL (one file per part) or Download 3MF (every part on one plate).

Questions

What size is the tafoni Wall model?

The tafoni Wall model measures 200 × 46 × 96 mm (width × depth × height). That is Base A; one more base is built on. You can change every size in the free SO3D.xyz generator before you download it.

Does it need supports?

It may need supports in places. Print upright in sandstone PLA. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.

How much filament does it use?

At most about 79.6 g of PLA (64.2 cm³ printed solid), roughly $1.59 of filament at $20 per kg. Normal infill uses less.

Can I change it?

Yes. Open it in the SO3D.xyz generator (free, in your browser), change the size, walls, dividers, holes, text or anything else, then download it as STL or 3MF for your slicer.