Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
One block per year, in a new colour each time. Glue in 10 x 3 mm magnets. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Pause at each terrace for a colour change: dark base to white summit. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print two, one for each city, in matching colours. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print in a soft pastel; matte PLA shows the engraving. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print as many rooms as storeys; a dab of museum putty locks the stack. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print the upper deck in white and the module in grey. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Print the hood upside down, roof on the plate.
Print face down in a sandstone tone; stand it on its long edge. Prints as shown on its floor, no supports.
Print flat in a bright colour. Scale the width with the slot to fit thicker edges.
Print in silver grey; the spinning base needs 6 mm steel balls. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Prism in silk gold or silver; plinth in black. Prints as shown on its floor, no supports. Stacked parts are fused into one print.