Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Keep doubles in GOT for swapping at school; the stickers you still need go in NEED, in album order. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
One number per bay; the last two bays take the small candles and a lighter. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print in orange with the pumpkin in black. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Screw it to the coop wall at back height; fill the left side with grit, the right with crushed oyster shell. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
The card stands in the slot on the stage; tuck a folded note under the lid. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
ASA or PETG; lay it with the hood facing away from the weather and run the cords through the side ports. Prints as shown on its floor, no supports. Print the hood upside down, roof on the plate.
Each bay fits a 75 mm mooncake; print in red or gold and line with paper. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Weight the base with a few coins if your wands are long. Prints as shown on its floor, no supports. The added base's lid prints separately.
Lay damp paper towel in each lane with 10 seeds, lid on, and count the sprouts after a week. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
The tube takes three rolled overgrips; dampeners go in the small bays. Prints as shown on its floor, no supports. The lid prints as a separate part, top down. The added base's lid prints separately.