Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Sand the hole edges smooth. Print in PETG for strength. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
Print in black. Lay the phone torch-up under the hole in the floor. Smaller holes give sharper stars. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Fits an A5 sheet rolled tightly. Print each capsule in a different colour. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Use MERV 13 or HEPA filter sheet cut to the wall size, and a 5 V USB fan. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Glue the lid on. Fits a 17-key tine set; drill the bridge holes to suit. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Leave the lid off overnight so the bar dries hard. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print in clear PETG to see the fill lines from inside. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print in green or gold. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Line the wedges with felt for delicate pieces. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Use a ball 40 mm or larger so it can't be swallowed. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.