Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print four in PETG; 10 mm rope. Prints as shown on its floor, no supports.
PETG. Use screws 3 mm longer than the originals. Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.
Print many in one colour or a gradient; 15 mm split rings. Prints flat as a plate, no supports.
Print flat in PLA; press or glue an M8 nut into each pad.
Print upright; drop a bag of sand into the base for weight. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print flat; print 100 %, 75 % and 55 % widths for three tiers.
Two 4 mm rods 260 mm long; twenty 20 mm wooden beads. Prints as shown on its floor, no supports.
Print three or four; 8 mm dowel. Prints as shown on its floor, no supports.
Print upright; push the dowel into the post. Prints as shown on its floor, no supports.