Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Prints as shown on its floor, no supports.
A drop of glue holds the bit for good. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Press in a 608 bearing (22 x 7 mm). Prints as shown on its floor, no supports. Stacked parts are fused into one print.
PETG. Sized for 130 mm road dropouts; add a washer for 135 mm. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Matt black PLA. Check your flash head size (here 77 x 47 mm). Prints as shown on its floor, no supports. Stacked parts are fused into one print.
PETG so the pipes stay airtight; 3 walls. Prints as shown on its floor, no supports.
PLA or PETG; add a 200 mm gum-rubber disc. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
PETG. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print two in food-safe PETG. Prints as shown on its floor, no supports.