Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print the upper deck in white and the module in grey. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Print the hood upside down, roof on the plate.
Print face down in a sandstone tone; stand it on its long edge. Prints as shown on its floor, no supports.
Print flat in a bright colour. Scale the width with the slot to fit thicker edges.
Print in silver grey; the spinning base needs 6 mm steel balls. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Prism in silk gold or silver; plinth in black. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print face up in white; glue a 10 x 2 mm magnet in the back. Prints as shown on its outline, no supports.
Print in batches; one colour per series. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print in the channel colour; scale the holes to your mic handle. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print in white with the lid relief in a second colour. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print in black or the band's colour. Prints as shown on its floor, no supports. Stacked parts are fused into one print.