Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print open end up, then stand it on its open end. Print floor-down as shown, then turn it over to use it.
Print upright. Holds a portrait postcard (105 x 148). Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print two in contrasting colours with different names. Prints flat as a plate, no supports.
Print lying flat; stand it on the baseline.
Print in silk or marble PLA at 100 % infill so it has weight. Prints as shown on its floor, no supports.
Print in black; fill with cork or putty. 6 x 2 mm magnet. Prints as shown on its outline, no supports.
Print lying on its profile; all parts come out solid. Prints as shown on its outline, no supports.
Print open side up, glue in a coin, then flip. Print floor-down as shown, then turn it over to use it.
Print a few; PETG keeps the tines straight. Prints flat as a plate, no supports.
Print as it comes (profile on the bed) in PETG or ASA; radiators reach 70 C.