Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
The legs print separately and press into holes under the bowl, so every part prints flat with no supports. Change the size in the editor, or add a wall pattern, to make your own.
Print the three legs separately and press them into the holes underneath; a drop of glue makes them permanent. Prints as shown on its floor, no supports.
Print the number of bins the badge shows. Because they are identical, any bin fits any spot. Prints as shown on its floor, no supports.
Fits jars up to 45 mm across and 105 mm long; ten jars per insert. Prints as shown on its floor, no supports.
Print a set at 100, 88 and 76 % so they nest one inside the next. Prints as shown on its floor, no supports.
Lanes fit medium and large hens' eggs. Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.
Float it in a jug of fresh water and add rice inside until the waterline sits on 0. Then each 20 g sinks it 12.5 mm to the next line. Prints as shown on its floor, no supports.
PETG with 5 mm walls and 15% infill so the walls trap air. Fill to 2 cm below the rim, freeze for about 20 hours, then lift the block out before the bottom freezes. Prints as shown on its floor, no supports.
Clear or natural PETG so you can see the egg. Fill with cold water to just below the rim. Prints as shown on its floor, no supports.
Takes flat tins up to 90 mm across (tuna, sardines, cat food). Print upright. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.