Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Body in any colour, lid in clear PETG. Three 8 mm steel balls. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Uses the lazy-Susan ball bearing base. Matt deck colour. Prints as shown on its floor, no supports. The lid prints as a separate part, top down. The turntable ring prints separately and runs on 6 mm BBs.
Print in two colours with a filament swap at 30 mm. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Print the drawer in a contrasting colour. Prints as shown on its floor, no supports. The drawer prints separately from the case. Stacked parts are fused into one print.
Print the lid separately, upside down. Prints as shown on its outline, no supports. The lid prints as a separate part, top down.
PETG; clean with alcohol before pouring agar. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print body and lid flat. Optional 10 mm magnet glued under the floor. Prints as shown on its outline, no supports. The lid prints as a separate part, top down.
Print in white or pearl PETG. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PETG. Print body and lid flat. Prints as shown on its outline, no supports. The lid prints as a separate part, top down.
PETG, 3 walls; PTFE tape on the thread. Test it with your keys first. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.