Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Drop toy bones in, pour plaster with a little sand, leave 24 hours, then lift the block out by the lid and dig with a brush. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Rows fit floats up to 280 mm; wrap the delicate tips in foam if you like. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print the turntable ring separately and drop in 6 mm steel or airsoft balls. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Print the sleeve upright and the two drawers flat; line the cells with felt for wooden pieces. Prints as shown on its floor, no supports. The 2 drawers print separately from the case.
Print the lid with the moon face up; a dark purple or black filament with gold text looks best. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Sized for travel checkers up to 34 mm across; scale the tubes for full-size checkers. Prints as shown on its floor, no supports. The lid prints as a separate part, top down. The added bases' lids print separately.
For dwarf species, glue fine mesh behind the vents. PETG takes the damp better than PLA. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print the lid in a speckled filament for a real egg look. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print in PETG; the slots let the goggles drip dry in the bag. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PETG; wash in warm soapy water, not the dishwasher. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.