Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
PETG or TPU, printed flat. Prints as shown on its outline, no supports.
Arches print bridged; no supports at 0.2 mm layers. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
Print upright; ledges self-support at 45 degrees. Prints as shown on its floor, no supports.
Print lying flat in dark green; all strokes come out solid.
Glue felt or rubber underneath. Prints as shown on its outline, no supports.
Print in PETG; print a few. Prints as shown on its outline, no supports.
Print ten or more in PETG. Prints as shown on its outline, no supports.
Print three or four in PETG. Prints as shown on its outline, no supports.
Print in PETG; plug metal shells need to be 7 mm long. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.